长沙LPS-S1 Diaphragm-Type Pressure Switch
● Fully welded diaphragm, zero leakage
●Mechanical principle, no power supply required
● High-quality microswitch with minimal dead zone
● The process interface is versatile, and both flange and threaded connections can be customized.
Category:
Product Description
Product Overview Product overview
The LPS-S1 series diaphragm pressure switches feature a fully welded stainless steel diaphragm, leveraging mechanical deformation to precisely control the target pressure in automated control systems. This approach represents one of the simplest and most reliable pressure protection solutions available, with a design that is both straightforward and easy to use, minimizing potential failure points while effectively preventing leakage and false operations. Thanks to these outstanding advantages, this series of pressure switches is widely employed across various industries—including petroleum, chemical processing, metallurgy, power generation, sugar production, pharmaceuticals, and more—where precise pressure control is essential.
Measurement Principle Principle
The diaphragm-type pressure switch is a mechanical pressure switch that uses the mechanical deformation of a diaphragm to control the closing or opening of electrical contacts. When the pressure of the measured medium changes, the diaphragm undergoes corresponding displacement. This displacement is then transmitted via a linkage mechanism to a microswitch. Once the displacement reaches a preset value, it actuates the microswitch, causing its contacts to either close or open—thus signaling the pressure level. Adjustable pressure switches allow users to fine-tune the relationship between the linkage mechanism and the microswitch contact travel, enabling precise pressure control either at a fixed value or within a specific range, thereby achieving the desired operational purpose.
Performance Metrics TECHNICAL PARAMETERS
Measurement medium: Gas or liquid (For highly corrosive applications, please consult us).
Housing material: Die-cast aluminum, epoxy resin coating, with a sealing gasket on the outer cover
NEMA Protection Rating: Meets NEMA 4X requirements
Set value accuracy: ±0.5%
Repeatability accuracy: <1%
Pressure interface: Standard 1/2 NPTF internal thread, M20×1.5 external thread; special interfaces available upon request.
Electrical interface: M20×1.5 internal thread; special interfaces available upon request
Switch output: One single-pole double-throw (normally open + normally closed) output;
Ambient temperature: -40°C to +70°C
Environmental humidity: 5%–95%
Cycle Life: 1 million cycles
Protection Rating: IP67
Explosion-proof rating: Ex de IIC T6 Gb
Dust Explosion Protection: ExtD A21 IP66 T80℃
Contact capacity: Standard type: 380V, 15A; Explosion-proof type: 380VAC, 5A;
External dimensions APPEARANCE OF SIZE
Installation Requirements INSTALLATION
1. Weld the pressure-tapping pipe, and it’s best to install a shut-off valve on the pipe. Leave threaded connections corresponding to the switch, allowing for easy removal of the switch during maintenance.
2. Install the switch in a location with minimal vibration and temperature fluctuations. An appropriate installation spot can effectively prevent moisture from entering the housing. If the switch will be installed under harsh operating conditions, it must be mounted vertically (with the pressure connector facing downward). Please avoid installing it in environments outside the specified temperature range.
3. Special note: When installing or removing, never directly twist the outer casing to secure or detach the switch. Instead, use a wrench to tighten or loosen the connecting hexagonal (or flat) fitting at the joint.
Tianjin Ling Yu Technology Co., Ltd.
Operator:86-22-58554679
Fax: 022-58285528
Manager Ding: 86-18902041592
WhatsApp：8618902041592
Complaint Hotline:86-15822286986
Factory Address: No.5 Yingbin Road, Xiqing District, Tianjin
E-mail:sales@lingyukeji.com
Purchasing Department E-mail:lykj_tj@163.com
WhatsApp Scan
Copyright©2022 Tianjin Ling Yu Technology Co., Ltd